contact us

Use the form on the right to contact us.

You can edit the text in this area, and change where the contact form on the right submits to, by entering edit mode using the modes on the bottom right.​

743 Rolling Stone Road
Kylertown, PA 16847
USA

814-345-5634

Equipment

This is some of the equipment and tools that we have to help us get the job done for you. We have Equipment to ditch and back fill for Underground electric. We also have aerial lifts for up to 60 feet for anything from overhead electric services to parking lot lights. We also have lifts that can reach the ceiling in your building to install conduits and lighting.  Need conduit bent or threaded we can do that too. We also have a full line of meters to help with most of electrical questions you have for us.

 
 
 
IMG_20161014_093058289_HDR.jpg

Bucket Truck

Our bucket truck will help us reach most parking lot lighting or anything electrical up to 60 feet.

 

Tow behind lifts

We have 2 of these lifts to get us in the air. They will reach 35 feet. Not only can we use them for a man lift, but they are rated for lifting loads into place such as lite poles, transformers, generators or even solar panels.

 
 
 
 
 
 
 

4/0 welded to a 5/8" groundrod

Scissor lift

This lift is able to fit through most normal doorways without having to remove any hardware.  At 32 inches wide and a platform height reaching 22 feet we can do a lot of work in your building.  

 

Ditching

Our ditcher is set up to Make a ditch 7 inches wide and up to 4 feet deep.   There is a small backhoe on this machine to aid the ditching ability.  There is also a blade to help with back filling after the conduit or wire is in the ground.

 

Skid Steer

Our skid steer we use for many things. From backfilling ditches to helping dig out for a base under a generator.  We also use it to help move other equipment around job sites and unloading trucks. It is a very useful to have on site for many jobs. 

 

bending and Threading

We have the equipment to bend all types of conduit.

  • hot box and heating blankets for up to 4 inch PVC conduit

  • Benders for up to 4 inch EMT conduit

  • Benders for up to 5 inch Rigid steel conduit

  • Threaders for up to 4 inch Rigid steel conduit

 

Hammer drills and drivers

We have Hammer drills and bits to drill concrete for up to a 5 inch conduit.

We can also use these to drive ground rods in for service grounding or ground beds.

 

Metering and monitoring

We have many tools to be able to help with all your electrical needs

  • Fluke power logging meter. This is used for power studies. to check for energy savings before and after improvements. Also to check for power spikes and sags to diagnose nuisance breaker tripping or equipment resets

  • Earth Ground resistance Tester. You always want to be sure you have a good ground to your building and equipment.

  • Line locator. we can use this to find existing buried water, gas, telephone, electrical lines before we dig. This does not replace doing a PA ONE Call before you dig!

  • Three phase rotation meters. you have to make sure your three phase equipment is running in the right direction before and after any power changes.

  • We also have Circuit tracers, multi meters and amp meters with us.

 

Exothermic connections

We have completed the Ultraweld exothermic connections class. this was given by Harger Lightning & Grounding.  We can use these connections anywhere there is a need for a permanent grounding connection between wire-to-wire, wire-to-ground rod, wire-to-steel. Anything from a ground bed to Lightning protection.